[. . . ] ⷠObey the safety instructions from the detergent manufacturer to prevent burns to eyes, mouth and throat. ⷠDo not keep the appliance door open without supervision. Do not use the appliance for other uses to prevent injury to persons and damage to property. ⷠOnly use the appliance to clean accessories that are applicable for dishwashers. [. . . ] ⷠMake sure that there is access to the mains plug after the installation. To prevent the risk of injury or damage: ­ Disconnect the mains plug from the mains socket. ⷠIf an accident occurs with these detergents, contact immediately a physician. ⷠIf the detergent gets into the mouth, contact immediately a physician. ⷠIf the detergent gets into the eyes, contact immediately a physician and clean the eyes with water. ⷠKeep dishwasher detergents in a safe area and out of children touch. ⷠDo not keep the appliance door open when there is detergent in the detergent dispenser. ⷠFill the detergent dispenser only before you start a washing programme. It comes on in these conditions: · When you adjust the level of the water softener. 1) After you fill the container, the salt indicator can stay on for some hours. This does not have an unwanted effect on the operation of the appliance. 1) When the salt container is empty, the related indicator does not come on while a washing programme operates. These indicators have also an auxiliary function when you: · With this button you can: · Use this button to delay the start of the washing programme with an interval of 3 hours. The appliance must be in setting mode for these operations: · Only one programme indicator comes on. ­ It is necessary to cancel the programme to go back to the setting mode. You can hear the acoustic signals in these conditions: · Press and hold the programme button until the programme indicator (A) flashes and the programme indicator (B) comes on. The programme indicator (A) comes on and the programme indicator (B) starts to flash. After some seconds, the programme indicator (A) goes off and the end indicator comes on. Be sure that the set level of the water softener agrees with the water hardness in your area. Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Press and hold the programme button until the programme indicator (A) starts to flash and the programme indicator (B) comes on. [. . . ] Make sure that an incorrect arrangement of the load does not cause a blockage of the spray arms. The filters are dirty or not asMake sure that the filters are sembled and installed correctly. There are streaks, milky stains, or a bluish layer on glasses and dishes. You have set a washing programme without drying phase or with a decreased drying phase. [. . . ]